Brands |
N/A Dytran |
Electrical Isolation |
N/A 10 GO |
Type |
N/A Integrated Electronic Piezoelectric (IEPE) |
Number of Axis |
N/A 3 |
Housing Material |
N/A Titanium |
Maximum Weight |
N/A 1.05 oz30 g |
Connector Type |
N/A 4-Pin |
Note for Connector Type |
N/A Glass to Metal seal connector. Mates with Dytran cable Model 6811AXX (XX=length in feet). |
Connector Material |
N/A Titanium |
Tapped Hole Mounting Provision |
N/A 10-32 United Fine (UNF-2B) |
Housing Isolation |
N/A Case Isolated |
Sensing Element Material |
N/A Single Crystal |
Sensing Element Mode |
N/A Planar Shear |
Maximum Peak Shock |
N/A 1500 g14715 m/s² |
Maximum Peak Vibration (±) |
N/A 1000 g9810 g |
Operating Temperature Range |
N/A -60 to +250 ºF-51 to +121 ºC |
Environmental Seal |
N/A Hermetic |
Base Strain Sensitivity at 250 Micro Epsilon (µe) |
N/A 0.002 g/µε0.02 g/µε |
Sensitivity |
N/A 10 mV/g1.0 mV/m/s² |
Note for Sensitivity |
N/A Measured at 100 Hz, 1 Grms per ISA RP 37.2. |
Resonant Frequency |
N/A >25 kHz |
Full Scale (F.S.) Linearity (±) |
N/A 1 % |
Note for Full Scale (F.S.) Linearity (±) |
N/A Measured using zero-based straight line method, % of F.S. or any lesser range. |
Root-Mean-Square (RMS) Broadband Resolution |
N/A 0.007 g0.07 m/s² |
Maximum Transverse Sensitivity |
N/A 6 % |
Peak Range for ± 5 Volts (V) Voltage Output |
N/A ±4905 g±500 g |
Frequency Response at ±3 Decibel (dB) Bandwidth |
N/A 0.3 to 5000 Hz |
Note for Power Supply Current |
N/A Do not apply power to this device without current limiting, 20 mA maximum to do so will destroy the integral IC amplifier. |
Compliance Voltage Range |
N/A +18 to +30 V |
Direct Current (DC) Operating Bias Voltage |
N/A 7.0 to 13.0 V |
Discharge Time Constant |
N/A 0.5 to 2.0 sec |
Transducer Electronic Data Sheet (TEDS) Feature |
N/A IEEE 1451.4 |
Typical Output Impedance |
N/A 100 O |
Note for Transducer Electronic Data Sheet (TEDS) Feature |
N/A TEDS operational temperature: -40ºF to +185ºF [-40ºC to +85ºC] |
Power Supply Current Range |
N/A 2 to 20 mA |
Supplied Accessories |
N/A
|
Note |
N/A
In the interest of constant product improvement, we reserve the right to change specifications without notice. It is the customer's responsibility to validate that a particular product with the properties described in the product specification is suitable for use in a particular application. Parameters provided in datasheets and / or specifications may vary in different applications and performance may vary overtime. All operating parameters, including typical parameters, must be validated for each customer application by the customer's technical experts. Units on the line drawing are in inches, units in brackets are in millimeters. |
