Sensing Element |
N/A Quartz |
Maximum Weight |
N/A 0.3 oz8.7 g |
Thru Hole Mounting Provision |
N/A Ø 4.8 mm Ø.19 Inches |
Number of Thru Hole for Mounting Provision |
N/A Ø 4.8 |
Housing and Connector Material |
N/A Titanium Alloy |
Element Style |
N/A Shear |
Side Mounted Connector |
N/A 10-32 Jack |
Temperature Range |
N/A -60 to +300 ºF-60 to +149 ºC |
Maximum Peak Shock |
N/A 2500 g24525 m/s² |
Maximum Peak Vibration (±) |
N/A 1000 g9810 m/s² |
Environmental Seal |
N/A Hermetic |
Transducer Electronic Data Sheet (TEDS) Operating Temperature |
N/A -40 to +185 ºF-40 to +85 ºC |
Transducer Electronic Data Sheet (TEDS) Feature |
N/A IEEE 1451.4 |
Seal, Accelerometer |
N/A Hermetic |
Full Scale (F.S.) Range for ± 5 Volts (V) Voltage Output |
N/A ±500 g±4905 m/s² |
Resonant Frequency |
N/A >50 kHz |
Full Scale (F.S.) Linearity (±) |
N/A 1 % |
Note for Full Scale (F.S.) Linearity (±) |
N/A Measure using zero-based straight line method, % of F.S. or any lesser range. |
Maximum Transverse Sensitivity |
N/A 5 % |
Sensitivity ±5% |
N/A 10 mV/G1 mV/m/s² |
Frequency Response ±5% |
N/A 1.6 to 5,000 Hz |
Frequency Response ±10% |
N/A .1 to 10,000 Hz |
Note for Linearity |
N/A Measure using zero-based straight line method, % of F.S. or any lesser range. |
Note for Sensitivity, ±30% |
N/A Do not apply power to this system without current limiting, 20 mA MAX. To do so will destroy the IC charge amplifier. |
Note for Sensitivity ±5% |
N/A Measure at 100Hz, 1 Grms per ISA RP 37.2. |
Strain Sensitivity @250µe |
N/A 0.003 g/µe0.03 m/s2/µe |
Root Mean Squire Equivalent Electrical Noise Floor |
N/A 0.005 g0.05 m/s² |
Discharge Time Constant |
N/A 0.3 to 2.0 sec |
Typical Output Impedance |
N/A 100 O |
Direct Current (DC) Bias Voltage |
N/A +7.5 to +9.5 V |
Minimum Electrical Isolation (Ground Pin to Case) |
N/A 10 GO |
Direct Current (DC) Compliance Voltage Range |
N/A +18 to +30 V |
Power Supply Current Range |
N/A 2 to 20 mA |
Note for Power Supply Current Range |
N/A Do not apply power to this system without current limiting, 20 mA MAX. To do so will destroy the IC charge amplifier. |
TEDS Feature |
N/A IEEE 1451.4 |
Minimum Case to Mounting Surface Isolation |
N/A 10 GO |
