COMPANY HEADER
Request Information
Piezoelectric Accelerometers are available with both IEPE and Charge Mode outputs. Different Accelerometer Types include - Airborne, Triaxial, Industrial, General Purpose etc and the measured acceleration ranges from 0.5g to 70000g.
Unit of Measure

Specifications

Brands

 N/A Dytran

Output Impedance of Integral Amplifier

 N/A 100 O

DC Bias Level of Internal IC Amplifier

N/A 10 V

Physical

Weight

 N/A 35 g

Environmental

Temperature Range

 N/A -65 to +250 ºF

Thermal Coefficient of Sensitivity

 N/A 0.3 %/°F

Performance

Full Scale (F.S.) Linearity (±)

 N/A 1 %

Maximum Transverse Sensitivity

 N/A 3 %

±5 Volts (V) Peak Acceleration Range

 N/A 500 g

Root-Mean-Square (RMS) Equivalent Electrical Noise Floor

 N/A 0.007 g

Operating Force Range (±)

 N/A 40 lbf

Top Mounting Holes

 N/A 1/4-28 UNF-2B

Bottom Mounting Holes

 N/A 10 to 32 UNF-2B

Note for Frequency Response

 N/A This specification valid only with test acclerometer mass of upto 20 Grams. Mass loading curves must be constructed to make up for changes in response due to mass loading of Acclerometer.

Frequency Response ±5%

 N/A 1 to 10,000 Hz

Sensitivity ±10%

 N/A 10 mV/g

Housing material (Non-magnetic)

 N/A Titanium

Input Current Range

 N/A 2-5 mA

Note for Input Current Range

N/A Must be used with constant current type power source. Do not connect power source to accelerometer without current limiting. This will destroy the internal amplifier.

Electrical

Compliance Voltage Range

 N/A +18 to +30 V

Discharge Time Constant

 N/A 0.5 sec

Minimum Electrical Isolation for Ground (Pin B) to Case (Pin A)

 N/A 10 MO

Electrical connector, Transverse MTD.

 N/A 3-PIN Solder Terminal Header